Professional grade fast setting adhesive for multiple wetroom applications.
Fast setting, waterproof, extra strong construction adhesive. Thousands of uses for the tiler, tradesman, builder and DIY enthusiast.
- Almost instant bonding to wood, metal, brick, stone and concrete.
- Sets in 5-10 minutes to an exceptionally high-bond strength.
- Waterproofs and reinforces joints.
- Replaces tape for all tile backer boards
- Totally waterproof even to seawater.
- 100's of other uses
Description
No More Ply Mega Strength Polyurethane Adhesive is a transparent one part moisture curing adhesive which sets in 5 minutes. The product is supplied as a thixotopical gel which is 100% seawater proof, gives exceptional high bond strength and is resistant to most chemicals. The product foams slightly on application to fill small gaps, which increases bond strength.
Areas of Use
- This product may be used internally or externally
- Used to bond most types of wood (hard, soft, exotic, painted wood), Formica, Polystyrene Foam, PU Foam and Glass Wool to porous surfaces.
- Also adheres to Metal, Stone, Concrete, Brick, Masonry and various Plastics.
- Typicl areas of use include wood jointing and construction, window and door frames, door manufacture, boat building, staircases, ladders and much more.
Limitations
- One of the surfaces must be porous
- Not suitable for polythylene, polypropylene, tefflon or nylon
- Moisture content of wood must not exceed 30% w/w
- As product expands slightly on curing, do not use on sheet laminate. Use Contact adhesive.
- Only apply between 5 and 30 degrees celcius.
- Ensure surfaces are always clamped during cure.
Storage - Store in cool, dry conditions - PROTECT FROM FROST
Shelf Life - 12 Months, less when cartridge has been opened
Application
- Surface to be bonded must be clean, dust and grease free. One of the surfaces must be porous. Roughen non-porous surfaces to give a key for the adhesive.
- To achive maximum bond strength and assist cure, slightly moisten one surface with a damp cloth. Do not over wet.
- Cut the tip of the cartridge taking care not to damage the thread.
- Applynozzle and cut cleanly at an angle of 45 degrees. Apply using a standard sealant gun. Wearing gloves is recommended.
- Apply adhesive evenly to one surface. If necessary, cover large surfaces with a fine toothed spreader. Assemble parts IMMEDIATELY and clamp for 5-10 mins (at 20 degrees celcius, longer at lower temperatures). After this time the joints may be easily handled. Final and full bond strength will be achieved after 30 minutes.
- NOTE: The product foams slightly on application to fill small gaps. Any excess foam/adhesive must be removed with acetone before the product sets, or with a sharp chisel once set.
Coverage - Sufficient for fixing approx 5 No. 1200 x 600mm NO MORE PLY tile backer boards.
Safety First - Always wear gloves
Login /
Basket
