LTP Grout Stain Remover - Grout, Cement, Lime and Efflorescence Remover.

A rapid action cleaning agent for removing cement residues, grout stain, efflorescence and other similar deposits from glazed and unglazed ceramics, terracotta, quarry tiles, slate and stone. May be used in dilute or concentrated form.

Recommended For Use With:

• Unglazed Quarry Tiles
• Glazed Quarry Tiles
• Terracotta
• Quarry Tiles
• Slate
• Some Stone *

* - Do not use on Limestone or when underfloor heating systems are in operation

Coverage: Light Use - 20 sq / m
                  Heavy Use - 10 sq / m

Product Selector

Instructions:
Important: - This product may not be suitable for use on all floor materials. Test the solution on a small inconspicuous area prior to general application.  When using acid solution, prolonged contact with grout joints should be avoided.  Any acidity remaining on surfaces treated with this product should be completely neutralised after use. This may be done with a little clean water applied by sponge.

Directions:
In mild cases and on absorbent tiles: Dilute 1 part Grout Stain Remover in 4 parts warm water.  Apply with a cloth or sponge wrung out in the solution.  Wipe off thoroughly with a clean damp cloth.

In more severe cases: Dilute 1 part Grout Stain Remover in 1 part warm water.  Apply liberally and spread over surface of tiles.  If necessary, agitate with a scrubbing brush and leave to react for 5-10 minutes, keeping wet with additional Grout Stain Remover solution.  Mop up and rinse thoroughly with clean water.

In extremely severe cases: Use undiluted and agitate with scrubbing brush if necessary.  Neutralise treated surface with clean water after use.

Coverage:
Approximately 5-25m2 per litre.

Attention:
Keep out of reach of children.
Avoid contact with eyes and skin.
In case of contact with eyes rinse with plenty of water and seek medical advice.
Do not use on surfaces which are sensitive to acids, eg chrome enamel or which contain lime, ie marble. In conditions of extreme humidity LTP Grout Stain Remover vapor may react with acid sensitive surfaces. Any contaminated surface should be rinsed off imediatly with a sponge and clean water.
In case of swallowing seek medical advice immediately and show this label.

This information is offered without guarantee.  The material should be used so as to take account of the local conditions and the surfaces to be treated.  In case of doubt, the product should be tried out in an inconspicuous area